Satellite Communication MCQs June 2021 Mumbai University Question Paper

Q1] MCQ based Paper: 40 marks

1) The Tracking system present in the earth station performs mainly two functions as ______.

    a) acquisition and tracking of earth station
    b) acquisition and tracking of the Sun
    c) acquisition and tracking of the Moon
    d) satellite acquisition and tracking of satellite.

2) In space qualification, components that have _______ reliability in outer space are selected.

    a) Low
    b) Medium
    c) High
    d) very low

3) Bandwidth used in LASER satellite communication is _______RF bandwidth.

    a) Larger than
    b) Equal to
    c) Smaller than
    d) depends on

4) The range between a ground station and a satellite is 42000 km. Calculate the free space loss a frequency of 6 GHz.

    a) 100dB
    b) 150dB
    c) 175dB
    d) 200.4dB

5) The traffic-handling capacity of an Earth station on the uplink depends on ______.

    a) its EIRP
    b) its antenna gain
    c) noise associated with the Earth Station
    d) received power at satellite

6) A master antenna TV (MATV) system is used to provide reception of __________to a small group of users.

    a) Conventional TV/AM channels
    b) DBS TV/AM channels
    c) DBS TV/FM channels
    d) Conventional TV/FM channels

7) Which of the following term is used to describe the microwave radiation which is present throughout universe and appears to originate from matter in any form at a finite temperature?

    a) Noise factor
    b) Antenna loss
    c) Sky noise
    d) Noise power spectral density

8) Double conversion transponder is used for _____ band.

    a) K
    b) Ku
    c) S
    d) C

9) What is the approximate time taken by the GPS for one complete orbit?

    a) 11 minutes
    b) 45 minutes
    c) 5 hours
    d) 12 hours

10) A satellite which simply reflects the signal without further amplification _______.

    a) Passive satellite
    b) Active satellite
    c) Geostationary satellite
    d) Domestic satellite

11) In TVRO, Outdoor unit mainly consists of ______.

    a) Transmitting antenna and Low Noise Block (LNB)
    b) Television Receiver
    c) receiving antenna and Low Noise Block (LNB)
    d) IF amplifier

12) Find the orbital period of the satellite in a circular orbit 500 km above the Earth’s surface.

    a) 1.6 hrs
    b) 3.2 hrs
    c) 2.4 hrs
    d) 6.4 hrs

13) What is the number of transponders if the satellite uses 12 channels of frequencyand frequency reuse is implemented ?

    a) 12
    b) 6
    c) 24
    d) 3

14) When two networks are connected in series, its composite noise figure can be given as ______.

    a) F1+(F2-1)/G1
    b) F1-(F2-1)/G1
    c) F2+(F1-1)/G1
    d) F1G1+(F2-1)

15) SCPC systems are widely used on lightly loaded routes, this type of service being referred to as a _________.

    a) thin route service.
    b) thick route service.
    c) busy route service.
    d) empty route service.

16) The CSC bandwidth is 160 kHz, and its center frequency is ______ below the pilot frequency.

    a) 18.045 MHz
    b) 18.045 kHz
    c) 1.8045 MHz
    d) 1.8045 kHz

17) A frame format of TDMA system includes.

    a) reference burst, preamble and traffic data.
    b) reference burst, guard time, preamble and traffic data.
    c) guard time, preamble and traffic data.
    d) reference burst, guard time and preamble.

18) In Satellite Radio sound quality is excellent due to a wide audio bandwidth of ______.

    a) 5–15 MHz
    b) 5–15 kHz
    c) 50-150KHz
    d) 50-150Hz

19) The angle between the line from the earth station’s antenna to the satellite and the line between the earth station’s antenna and the earth’s horizon is called as ______.

    a) Angle of inclination
    b) Angle of elevation
    c) Apogee angle
    d) Angle of azimuth

20) The rotation about ________ axis is called pitch in 3-axis stabilization.

    a) X
    b) Y
    c) Z
    d) W


Post a Comment

0 Comments